SRS Unit Removal and Installation

SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.


NOTE: Wait at least 3 minutes before starting work.

3. SRS Unit - Remove
1.
Remove the duct (A).
2.
Remove the clip (A), then disconnect the connectors (B).
NOTE: The SRS unit connectors have lever locks. Release the locks before disconnecting the connectors.
3.
Remove the bolts (C), then remove the SRS unit (D).

4. All Removed Parts - Install
1.
Install all of the removed parts in reverse order.
NOTE:
During installation, install the new bolts to the specified torque.
Before installing the center console, make sure the SRS indicator works normally.
Make sure the SRS unit has the latest software. If it does not have the latest, update the software in the SRS unit.


NOTE: After replacing the SRS unit with a new one, memorize the yaw rate-acceleration neutral position.


NOTE: After replacing the SRS unit with a new one, initialize the front passenger's weight sensors.

7. SRS Operation - Confirm
1.
Turn the vehicle to the ON mode, and check that the SRS indicator comes on for about 6 seconds and then goes off.