12 Volt Battery Terminal Disconnection and Reconnection

NOTE: Canada models: When turning the vehicle to the ON mode for the first time after the 12 volt battery is reconnected, turn the vehicle to the ON mode while depressing the brake pedal for the immobilizer mutual authentication between the body control module and the VSA modulator-control unit.

1. 12 Volt Battery Terminal - Disconnect

USA and Mexico models

Canada models
1.
Make sure the vehicle is in the OFF (LOCK) mode.
2.
Disconnect and isolate the cable with the 12 volt battery sensor (A) from the 12 volt battery.
NOTE:
Always disconnect the negative side first.
To protect the connector (B) from damage, do not hold it when removing the terminal.
Do not disconnect the 12 volt battery sensor from the cable (C).
3.
Open the cover (D).
NOTE: If necessary, remove the cover.
4.
Disconnect the terminal (E) from the 12 volt battery.

1. 12 Volt Battery Terminal - Connect

USA and Mexico models

Canada models
NOTE: If the 12 volt battery performs abnormally, test the 12 volt battery.
1.
Clean the 12 volt battery terminals.
2.
Connect the terminal (A) to the 12 volt battery.
NOTE: Always connect the positive side first.
3.
Connect the cable and the 12 volt battery sensor (B) to the 12 volt battery.
NOTE: To protect the connector (C) from damage, do not hold it when installing the terminal.
4.
Apply multipurpose grease to the terminals to prevent corrosion.
5.
Close the cover (D).